Low-profile design to reduce sloshing during run

High flow bite valve allows for easy access to water and doesn’t drip when not in use

Includes quick release hose for convenient cleaning and set up

Compatible with most Nathan® Hydration Vests and Packs

Large opening allows for easy fill and cleaning

HOW TO CLEAN A HYDRAPAK BLADDER

Step 1: Fill bladder and hose with warm soapy water, shake bladder and hose
Step 2: Remove soapy water, detach hose and turn bladder inside out
Step 3: Use warm water to rinse thoroughly both hose and bladder
Step 4: Turn bladder upside down over paper towel holder, or stuff with paper towels, and leave hose on dry rack

Enjoy your run!

HOW TO TRIM A NATHAN HYDRAPAK HYDRATION HOSE

Step 1: To ensure you find the right length, place the bladder in the hydration pack opening at the top
Step 2: Secure the bladder to the vest
Step 3: Pull the hose through the left or right hole at the top of the pack and bring the hose to the front strap
Step 4: Secure the hose to the clip and then bring the hose to your mouth to confirm the best length
Step 5: Use a pen to mark the best length of the hose
Step 6: Remove entire bite valve and use scissors to cut the hose to the desired length
Step 7: Use firm grip to reattach the hose. Make sure that the valve is fully secured before using

Enjoy your Run!